Description
This 9″ may look stock, but there is nothing stock about it. It starts out with an after market center housing that is twice as thick as a factory housing, with three inch OD 1/2″ wall dom tubing. We can use either Moser deep bore housing ends that looks very similar to a stock end or Postalmopar housing ends (we prefer ours if rules allow). This rear end comes with HD leaf/coil pads, upper ears and a pinion brake. We use a nodular iron third member and a pro race 35 spline pinion gear set, depending on gear ratio. We take the time to fill them with oil, and break the gears in properly so there is no surprise work once received. Our 9″ rears come standard with 40 spline Moser axles with bronze bearings, choice of bolt pattern, and choice of gears. If there is a gear ratio that you prefer and is not listed please contact us.
Additional Axle Flange Patterns are available. Please contact us for these special orders by phone or email.
- 5 on 5.5 (+$20)
- 9 (10) ON 4.5 (+$80)
- 9 (10) ON 5 (+$80)
Extra options are also available. Please contact us for these special orders by phone or email.
- UPPER EARS JIGGED ON (+$100)
- CADILLAC UPPER BRACKETS JIGGED ON (+$105)
- UPGRADED AXLES (+$300)
- LOWER SKID PLATE (+$150)
- 5.00 AND DEEPER GEARS (+$350)
Axle Saver housing ends are also available on this setup for an extra $380. Please contact us for this special order by phone or email.
Shipping can range from $375 to $675 depending on the area. Please contact us for a custom shipping quote.
